1. Input connector: F-connector. 2. Output connector: F-connector. 3. Down-conversion output: baseband I and Q signal. 4. Channel selection system: PLL synthesizer ( clock 4.0MHz I2C bus interface ).
1. This specification applies to FM/ AM varator tuner and FCC and E- mark authentication. 2. Unit should not have any excessive stain, bruise, uneven plating, etc which decrease its commercial value. 3. Receiving system. (1) FM section: ...
1. Option with DC- power output through input connector ( e.g. indoor antenna supply). 2. Tuners comply with relevant cenelec standards with regard to requirements concerning signal handing capability and immunity. 3. Superior low noise ...
1. Option with DC- power output through input connector ( e.g. indoor antenna supply). 2. Tuners comply with relevant cenelec standards with regard to requirements concerning signal handing capability and immunity. 3. Superior low noise ...
Cable connector: RF input and RF output ( F- connector, IEC connector, pin type ).
1. Input connector: F-connector. 2. Output connector: F-connector. 3. Channel selection system: PLL synthesizer ( I2C bus: STB6100 or equivalent clock: 27MHz).
1. Input connector: F-connector. 2. Output connector: F-connector. 3. Channel selection system: PLL synthesizer ( clock 4.0MHz I2C bus interface).
1. FM/ AM part. (1) High sensitivity and high image rejection. (2) Mixer for 1st IF 10.7MHz; mixer for 2nd IF 450KHz. (3) Fully integrated FM demodulator with spike cancellation. (4) AM IF- and audio noise blanking. 2. Stereo ...
1. Input connector: F-connector. 2. Output connector: F-connector. 3. Channel selection system: built in PLL ( I2C bus: CX24113 or equivalent, clock: 10.111MHz ).
1. Input connector: F-connector. 2. Output connector: F-connector 3. Channel selection system: PLL synthesizer ( clock 4.0MHz I2C bus interface).
| Company Name : | Earda Electronics Co., Ltd. |
|---|---|
| Contact Person : | Ms. Vicky Zuo  |
| Country : |  China |
