1. Ø35 motor pin stud was specialized for 35mm tubular motor use only. 2. It was usually operate with bracket pin stud and used for light shutter operation system. 3. Good motor pin system can make stable operation performance.
1. Mounting stud was designed for tubular motor at the head of tube. 2. It was suitable for shutters and heavy operation system and it have to opoerate with motor square bolt pin stud. 3. It can offer good and stable holding performance for ...
1. Ø12mm shaft stud was designed for install at the end of tube. 2. It was suitable for blind or projection screen operation system for reduce gap between the wall. 3. It can be screwed on wall bracket or fixed on the wall directly.
1. Ø12 bearing was designed for tubular motor installed at the end of tube. 2. It was suitable for shutter and heavy operation system. 3. It have to opoerate with Ø28 bearing bracket and it can offer good lubricity performance for operating.
1. Ø65 octagonal aluminum tube was designed for TESC 45mm tubular motor. 2. It was operate with octagonal drive adapter. 3. Tubular motor have to insert into aluminum tube, then it work. 4. Length of tube will depends on width of your ...
1. It was designed for shutters and manual door. 2. It can be operate with manual slats and other shutter system. 3. Spring wire can make you lift shutters easier.
Paint-coated material and there two different specification for manual use only. They are Pulley 145 and Pulley 180. It can make shutter lifted easilier.
| Company Name : | Tong Eann Shutters Co., Ltd. |
|---|---|
| Contact Person : | Ms. Jessie Chen  |
| Address : | No. 22, Lane 130, Huh Ann Rd., Ching Sho |
| Country : |  Taiwan |
| Telephone : | 886-4-26112999 |
| Fax : | 886-4-26112826 |
