Machine Features
I. MITSUBISHI M70 High-level control system
i. Three-axis, low-inertia, high-torque motor to do three-axis control, three-axis simultaneous engraving and milling
ii. Ultimate PLC human machine interface detect and display each warning message
II. Build-in High Speed Spindle, high-rigidity, high-speed design
III. Patented Auto Tool Changing Device provide precise repeat positioning. Multi-process workpiece completed in one time, avoid workpiece moving. Yield rate and efficiency are improved.
IV. Full casting body, providing a stable machining process and tool life. Processing efficiency in the lead of the industry, complete nearly non-cleaved grinding edge
V. 90° vertical X-axis structure and anti-standard Z-axis, match vertical beams structural rigidity better than double column ones, provide stable and lightweight performance, effectively inhibit the resonance, arrive at the best cutting surface, extending tool life
VI. Each axis equipped 4 precision bearings, backlash error tends to zero after pre-loading pre-tension precision screw
VII. Each stack of surface contact is precision shovel to assemble accurately. (Shovel skill is non-temperature processing technology to correct the thermal deformation grinding lead to sophisticated assembly and eliminate machine resonance.)
VIII. Hermetic separation of electrical heat cabinet, which can effectively isolate heat, grease, increase the stability machine life
IX. Rear flush design, which can effectively remove iron filings and easy to clean
X. Cutting liquid and rail oil are separated by Oil Separation System. It brings no pollution to workpiece and extend cutting liquid life time
XI. Well-designed automatic lubrication systems with metal material pipe, so that each machine does not occur lubrication problem and lubrication pipe burst or aging issues, to ensure the accuracy of transmission parts
XII. Automatic tool measurement system designed to do tool length correction, so that processing object to achieve the best accuracy
XIII. BALL BAR dynamic laser positioning and dynamic through the circle check make TECH PLUS machines head for international standards
Controller: MITSUBISHI
M70 System: WinCE
Ethernet: RS232 / RJ45
X.Y.Z Travel: 1110*800*200 mm
X.Y.Z Rapid Traverse: 20000 mm/min
Spindle Nose to Table: 75 - 275 mm
Spindle Speed: 12000 rpm
Spindle Motor: 10.6 kw
Spindle Taper: BT30
ATC: Manual Table Size: 960*650 mm
Max. Loading: 300 kgs
T-Slot: 12*6*100 mm
Machine Size: 2080*2265*2060 mm
Machine Weight: 4000 kgs
Power: 10 kv Air: 6 kgs/cm2
Taiwan
