Introduction:
This machine is specially design for outer insulation coating. It can coat the epoxy powder on surface of the electronic parts uniformly to get the insulation, damp-proof and increase the mechanical strength.
It is suitable for the film capacitor, ceramic capacitor, resistor, IC, PTC, NTC, etc.
Feature:
1. Control system by OMRON PLC controller, with touch screen to display the whole coating process.
2. The user could set the temperature of heating box according to the actual demand, temperature controller sets easy and fast.
3. Power Source: 380V, 10KW.
4. Air Pressure: 10kgs.
1. Preheating: heat for the first time after the element enters the machine.
2. Fluidize: compress air to squirt evenly, coatingmaterial boils into a state of gruel to reach the purpose of loosing and cooling for powder.
3. Powder settling: it is the process for settlingthe powder after powder fluidizing.
4. Shave powder: after the powder settling is finished, shave the excess powder from right to left side, to level the surface.
5. Soaking: soak the heated elements into the powder after shaving the powder, and then the surface of elements are coated with powder.
6. Vibration: vibrator will shake after the element is soaked in the powder in order to flow fast for the powder.
7. Beat and vibrate: elements rise to mid position after the soaking is finished, and then the frame is beat to remove the excess powder by the cylinder.
8. Melt powder and gloss: final heating after element is coated. The powder changes from solid into melt, and then become glossiness.
Taiwan
