The Best of Made in Taiwan
Being a professional punching tool manufacturer with leading techology, Tai Cheng always does the best for considering and fulfilling that customers' needs and demands. A wide range of punching tools produced and provided by Tai Cheng is for meeting diverse requirements in the compatitive marketing of hand tools. Tai Cheng punching ...
Being a professional punching tool manufacturer with leading techology, Tai Cheng always does the best for considering and fulfilling that customers' needs and demands. A wide range of punching tools produced and provided by Tai Cheng is for meeting diverse requirements in the compatitive marketing of hand tools. Tai Cheng punching ...
The triple tool holder fits directly to the turret and is used to hold three standard 10mm square tool bits or for spacing two tools. The tool holder body is made of hardened steel.
The boring tool holder is for direct application to the eight station turret. It is used for holding 20mm diameter boring bars, turning tools or split bushings. The body of the boring tool holder is made of hardened steel. Specify 12mm or 3/8" or 1/2" tool silde center height when ordering.
The adjustable tool holder permits setting of center drills, drills, reamers and other end-working tools to the exact center of workpiece. The holder is mounted directly to the eight station turret and holds 5/8" diameter tool shanks or bushings in a ground-finish hole. Specify 12mm or 3/8" or 1/2" tool slide center ...
Extension tool Holders are used for turning or, with optional holders, for boring knurling or cutoff. Extension tool Holders are available in four Sizes 5mm, 75mm;, 100mm and 125mm lengths (measured from centerline of T-bolts to extension end of holder). Holders mount directly to the chucker turret and take standard 3/8" square tool bits ...
This tool holder has an opening 11mm x 54mm, permitting the use of standard 3/8" square tool bits in any multiple tool capacity. By using the under-cutting, chamfering and grooving can be done in one operation. When ordering, specify whether the holder is to be used in the front or rear position.
Special York/ Tecumseh, Chrysler RV-2 (two cylinder) seal set All specialized tools needed to replace seals on the above compressor used with tools of 58501 Clutch Holding tool from 59012.
This tool holder center high is 10mm, can choose Right or Left hand tool holder.
To cut the telephone cables, steel ropes, round bars, aluminum. Hydraulic separate type of cutting tools.
Taiwan 
